What Size Regulator is Required for 10,000 BTU Ventless RV Heater

Question

Question:

I have a hundred pound propane tank what size regulator do I need for a 10000 BTU ventless heater

asked by: Brenda P

0

Expert Reply:

RV ventless or vent-free heaters need a low pressure propane source which is what the Camco Single Stage Propane Regulator # CAM59013 would provide when used with your 100 lb propane tank. Low pressure propane is rated at 11 inches of water column which is what this regulator is designed for.

expert reply by: Jameson C

0

Answer 1

The gas appliance itself (your heater in this case) will determine what regulator is necessary. The instructions included with the heater should list an “inlet pressure” required for minimal performance. It’s either listed as W.C. (Water Column 7-14)…

view full answer...

Answer 2

I would recommend going with a single regulator just so you don't have to ever worry about the capped off portion. Dual tank regulators are designed to switch off the empty tank when it's empty but a single tank regulator will be the better…

view full answer...

Answer 3

A single stage regulator can work just fine like with the Camco Regulator part #CAM59013 that you referenced. But if there's a very large distance between the tank and the appliances that is when a dual stage regulator makes the most sense like…

view full answer...

Answer 4

Though your heater unit has a built-in regulator, it is only capable of handling a very narrow flow rate range. For this reason, it's best to not consider an appliance's built-regulator as a replacement for the second stage for a two-stage…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

What Size Regulator is Required for 10,000 BTU Ventless RV Heater

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching