Where to Connect Manual Crank on Lippert Jack

Question

Question:

Where would I find the spot to use the hand crank the tongue of the trailer up or down?

asked by: Tina C

0

Expert Reply:

The manual crank # LC285324 is inserted into the top of the head unit for the Lippert Electric Trailer Jack # LC285318. You first need to remove the rubber plug to gain access to the attachment point (see attached photo).

expert reply by: Jon G

0

click to enlarge

Answer 1

We don't have any internal repair kits for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590 as they are not available but we do have replacement jack legs like the part #LC362485 which would replace the damaged…

view full answer...

Answer 2

The Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift #LC298707 or #LC369774 only come with the motor. You can get a replacement motor and replacement arms but the main support beam and legs are…

view full answer...

Answer 3

It sounds like you have the Lippert Ground Control Auto Leveling Landing Gear 3.0 part #LC358590 and are looking for replacement front landing gear legs. For that you would want the part #LC305340 . The part number for the rear would be #LC344792…

view full answer...

Answer 4

It sounds like the landing gear leg in question may have been over extended. If the leg seems to be slipping and has trouble extending (but you can still hear the motor turning) then this is likely what happened and it probably damaged/stripped the…

view full answer...

Answer 5

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been stripped or…

view full answer...

Answer 6

I answered that question a very long time ago before we were carrying the 6 point system #LC675817. That's why I wished we carried it...not that I wish we had it for that guy but that we just carried it in general as people at the time were…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...