Solution for Jammed Lippert Heavy Duty Landing Gear Leg
Question:
What would cause a front landing gear leg to jam in full up position? Lippert pn #241846. I thought there should be a limit switch to prevent this situation. Will a rebuild kit solve my problem?
asked by: Paul Y
Expert Reply:
It sounds like the landing gear leg in question may have been over extended. If the leg seems to be slipping and has trouble extending (but you can still hear the motor turning) then this is likely what happened and it probably damaged/stripped the gears. You can try removing the end cap to take a look at the bevel gears as you turn the manual crank handle to see if they are no longer engaging.
The correct repair kit for your Lippert landing gear leg is the part # LC146059. This kit includes the lead drive shaft, 2 drive shaft bushings, 1 E-Clip, 1 drive pin, 1 spiral pin, 1 12T bevel gear, 1 16T bevel gear, and 1 shim washer. If the gears were damaged on the leg then this kit will work great and should get the system working again.
If you notice any physical damage to the leg itself though a full replacement with part # LC241846 will be your best option.
Products Referenced in This Question
Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Lippert
more information >
Product Page this Question was Asked From
Replacement Heavy Duty Driver Leg for Lippert Ground Control 2.0 Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Continue Researching
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Shop: Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1
- Q&A: Solution for Damaged Front Jack Leg of Lippert Ground Control 3.0 Leveling System
- Search Results: lippert landing gear
- Q&A: Replacement Fuse Availability For the Lippert Ground Control 3.0 5th Wheel Leveling System
- Q&A: Troubleshooting Lippert Ground Control Rear Jacks that Wont Retract and Light Flashing
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Replacement Equalizer for E-Z Flex Suspension Kits - 1-3/4" Double-Eye Springs - Triple Axle
- Q&A: Replacement Landing Gear Legs for Lippert Ground Control 3.0
- Q&A: Can You Get the Lippert Electric Stabilizer Jack Without the Motor?
- Q&A: Troubleshooting Lippert Power Jack Not Extending or Retracting But Motor Is Working
- Q&A: Where to Connect Manual Crank on Lippert Jack
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 8,000 lbs
- Video: Review of Lippert Components Trailer Jack - Camper Jack - LC241846
- Video: Stromberg Carlson Trailer Jack LG-179014 Review
- Shop: Fifth Wheel Hitch
- Shop: RV Camera
- Shop: RV Covers
- Shop: Blind Spot Detection
- Search Results: landing legs
- Search Results: lg 179014
- Search Results: 241795
- Video: Review of Lippert Components - RV Exterior - LC287298
- Search Results: landing gear parts
- Search Results: 5th wheel landing legs
- Video: Review of Lippert Components - Trailer Jack,Camper Jack - LC146059
- Video: Kodiak Disc Brake Kit Installation K2HR712DS
- Video: HydraStar Electric Over Hydraulic Disc Brake Actuator Installation