Solution for Damaged Front Jack Leg of Lippert Ground Control 3.0 Leveling System

Question

Question:

Does this work on a Lippert ground control 3.0 front jack

asked by: Brian T

0

Expert Reply:

We don't have any internal repair kits for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 as they are not available but we do have replacement jack legs like the part # LC362485 which would replace the damaged leg you have now and get you back going!

expert reply by: Jameson C

0

Answer 1

The Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift #LC298707 or #LC369774 only come with the motor. You can get a replacement motor and replacement arms but the main support beam and legs are…

view full answer...

Answer 2

It sounds like the landing gear leg in question may have been over extended. If the leg seems to be slipping and has trouble extending (but you can still hear the motor turning) then this is likely what happened and it probably damaged/stripped the…

view full answer...

Answer 3

The manual crank #LC285324 is inserted into the top of the head unit for the Lippert Electric Trailer Jack #LC285318. You first need to remove the rubber plug to gain access to the attachment point (see attached photo).

view full answer...

Answer 4

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been…

view full answer...

Answer 5

I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.

view full answer...

Answer 6

I did some checking and the Fulton line of landing gear was discontinued in 2000 and there are no longer any replacement parts listed for it. Since you need 2 motors anyway, now would be a great time to replace the landing gear. For a system that…

view full answer...

Answer 7

Thanks for the pictures! Based on the part number of your motor it appears you have Venture landing gear. As such you will likely need follow leg rebuild kit #LC146060 or lead leg rebuild kit #LC146059 to fix your landing gear. Landing gear legs are…

view full answer...

Answer 8

To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions for the entire kit for the replacement gear and shaft kit for your Venture landing gear leg. The instructions…

view full answer...

Answer 9

I linked the schematic diagram for Lead Jack Repair Kit #LG-146059 taken from the written instructions. The complete instructions will be sent to you in a separate link. The follow leg repair kit is part #LC146060 in case you need it.

view full answer...

Answer 10

I do not have an exact replacement - but I have something similar. Your Jensen VR125 stereo measured 3-1/2" tall by 7" inches wide. The Jensen #JWM45 stereo measures 3-3/8" tall by 8-3/16" wide. The odd sizing of your radio makes…

view full answer...

Answer 11

The larger gear of the #C37ER has an inner diameter of .587 inch and the smaller gear has an inner diameter of right at 1/2 inch.

view full answer...

Answer 12

The Stromberg Carlson #LG-2 electric landing gear kit is typically a universal fit if the leg length and the weld stops on the legs match what you have existing. The legs on the #LG-2 are 33-1/2 inches long and the inside to inside weld stop…

view full answer...

Solution for Damaged Front Jack Leg of Lippert Ground Control 3.0 Leveling System

Product Page this Question was Asked From

Continue Researching