How Many Jacks Are Included with Lippert High-Speed Power Stabilizer Jack # LC298707

Question

Question:

In the order come the pair or they sold separate?thnx

asked by: Leo

0

Expert Reply:

The Lippert Components High-Speed Power Stabilizer Jack # LC298707 referenced in your question includes 1 stabilizer jack that can be used for either a front or rear mount application on your camper.

This electric stabilizer jack will give you up to 30 inches of lift and can automatically adjust to the terrain so uneven ground is not an issue. I have attached a short video demonstration on this product so you can get an even closer look at its features.

expert reply by: Chris R

0

Answer 1

On the Lippert High-Speed Power Stabilizer Jack #LC298707 you will want to test the different components to determine if it is the switch or possibly another component of your system. First I recommend running the jack manually to determine if you…

view full answer...

Answer 2

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 3

The support arms for the jack #LC298707 may be slightly tweaked from the camper rocking or travel. This can cause the legs to get hung up in the storage channels on the trailer. I recommend watching the leg as it goes up and see if it is getting hung…

view full answer...

Answer 4

The Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift #LC298707 has a threaded rod that runs from one side to the other. It sounds like there is an issue with the leg either showing a little resistance…

view full answer...

Answer 5

The Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift #LC298707 you asked about does have a single motor, but it will allow for leveling on uneven ground as the arms work independently. I've…

view full answer...

Answer 6

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been stripped or…

view full answer...

Answer 7

If the jacks are working most of the time, but blowing the fuse between campsites, it is most likely a ground issue. This could be loose, but could also be just a bad connection somewhere. I suggest checking all your ground connections on both the…

view full answer...

Answer 8

A corroded circuit breaker could certainly account for the sporadic operation of your trailer's powered stabilizer jack. So could loose or corroded wiring or connectors. For a new breaker you can use part #LC134181. This is a 6-amp auto-resetting…

view full answer...

Answer 9

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need to do is use…

view full answer...

Answer 10

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 11

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 12

Yes, the Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are definitely an upgrade over standard trailer stabilizers. The drop down feature makes it a lot quicker to get the jacks up and tucked out of the way so they don't catch when the…

view full answer...

How Many Jacks Are Included with Lippert High-Speed Power Stabilizer Jack # LC298707

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching