Buyers Products 2 Pintle Hook Mount # 337PM90 Come with Mounting Hardware

Question

Question:

Does this come with the 4 bolts or do you need to buy separately?

asked by: Steve M

0

Expert Reply:

Buyers Products 2" Pintle Hook Mount # 337PM90 does not come with hardware to mount a pintle hook to it. Some of the pintle hooks come with hardware, such as Curt model # C48210. Or if you just need hardware you can use # C48330.

expert reply by: Michael H

0

Answer 1

The ball weight carrying capacity of the Tow Ready Pintle Combo #C48200 is 16,000 pounds when used as a ball mount as long as you keep the 2-5/16 ball. If you would purchase a 2" ball to use with th #C48200 this capacity drops to 10,000 pounds.…

view full answer...

Answer 2

If your 2002 Chevy Silverado 3500 features the standard factory rear bumper (and not a 10 inch deep drop bumper) then the correct Curt hitch is the Class V #C15312 that you referenced. I have attached an image that shows the difference between a…

view full answer...

Answer 3

I did some checking and basically the cutout bumper is the regular factory bumper. The Curt hitch, #C15312, will fit up tighter and a little more recessed, apparently the same way the factory hitch does if it were installed. Some people like the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...