Recommended Slide Out Awning Slide-Toppers Based on Flange to Flange Measurements

Question

Question:

I have two slide outs one is 73.25” the other is 103” can you please give me recommendations for everything I would need to install a slide topper on both of my slide outs Thank you for your help

asked by: Anthony M

0

Expert Reply:

For your slide out that is 73.25 inches if that measurement includes the flanges on the sides, then you will use the Solera 6.5' Slider (Slide-Topper) in Black w/ Black Hardware # LCV000165063. If that measurement didn't include the flange on either side and with the flange you are over 73.75 inches, then you would want the Solera 7' Slider (Slide-Topper) in Black w/ Black Hardware # LCV000168105.

For your 103 inch slide out the same thing will happen. If you measured from flange to flange, you will use the Solera 9' Slider (Slide-Topper) in Black w/ Black Hardware # LCV000168108. If not and the flange to flange is over 103.75 then you will use the 9.5 foot # LCV000168325.

Most of the trailers and RV's have the rail extrusion needed to connect the awning already installed at the factory. If not, you can use the Solera Rail Extrusion - Black - 8 ft Long # LC715217. This is the only length we carry but it can be cut to length or installed end to end for custom fits. For that installation, I also recommend the Camco RV Vent Installation Kit - Rubber Roofs or Sidewalls - White Butyl Tape # CAM25013.

expert reply by: Jason S

0

Answer 1

To know what slide out awnings are going to be a correct fit for your slide outs you'll need to measure from the outside of the flange edge to outside of the other flange edge to ensure that the awning will fully cover the box with a little…

view full answer...

Answer 2

First it is important to verify the measurement point on your 2022 Jayco Eagle HT 24RE. If your 145" measurement is the widest point and includes the flange on both sides then you will want the Solera RV Slide-Out Awning in White…

view full answer...

Answer 3

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 4

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 5

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement for…

view full answer...

Answer 6

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 7

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 8

I recommend to use the Solera 16-1/2' Slider part #LCV000435661 which matches the boxes width exactly so you will not have side overhang like we normally recommend but it is the biggest slide topper available to fit the 198" width of your…

view full answer...

Answer 9

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and the…

view full answer...

Answer 10

We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides 188-193-3/4 inches, so…

view full answer...

Answer 11

I checked the owner's manual for your 2021 GMC Yukon XL, and yes, it is perfectly fine to flat tow. That being said, you are going to need these components: - A base plate - Tow bars - Braking system - Tow bar wiring - High-Low adapter For a base…

view full answer...

Answer 12

Great question, we have all that you need to flat tow your 2022 Yukon XL Denali. I will list the items then the details. Blue Ox Base Plate Kit - Removable Arms #BLU58FR. Blue Ox Avail Non-Binding Tow Bar - Motorhome Mount - 2" Hitch - 10,000…

view full answer...

Recommended Slide Out Awning Slide-Toppers Based on Flange to Flange Measurements

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching