Trailer Hitch Recommendation that Fits 2018 Lexus RX 450H

Question

Question:

Do you have a trailer hitch for a 2018 Lexus RX 450H?

asked by: W

0

Expert Reply:

We have the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" # e49KR as a confirmed fit for your 2018 Lexus RX 450H. I attached the installation instructions for you.

expert reply by: Jameson C

0

Answer 1

I'm assuming that you're needing to know so you can choose the correct wiring harness, correct? You could call your Lexus dealer and give them your VIN, and they should be able to tell you how your RX350 is equipped. Or, you could remove the…

view full answer...

Answer 2

I have taken a look at the Draw-Tite Max-Frame Trailer Hitch Receiver item #75540. This hitch is confirmed to fit your 2022 Lexus RX 350 and it does require some minor trimming of the lower portion of the rear trim. I have linked a couple of pictures…

view full answer...

Answer 3

I would recommend the Draw-Tite Trailer Hitch #75153 over the Curt #13530 for your 2009 Lexus RX 350. Curt has been revising their instructions on many hitches to include that per their warranty with any non-trailer load, like bike rack or cargo…

view full answer...

Answer 4

We do offer a hitch receiver that will fit your 2022 Lexus RX 350. It is the Curt Trailer Hitch Receiver - Class III - 2" #C73DR. It is custom fit and will attach to your Lexus with included hardware that requires no drilling. This hitch…

view full answer...

Answer 5

The Curt T-Connector Vehicle Wiring Harness for Factory Tow Package #56083 requires your 2021 Lexus RX 350 to have the factory tow package which includes a factory installed module to power the trailer lights. Since your harness does not have power I…

view full answer...

Answer 6

I would be happy to help! The Curt T-Connector Vehicle Wiring Harness #C56217 you were looking at installs in your 2021 Lexus RX 350 the exact same way as it would get installed in a Toyota Highlander which is why the instruction manual only shows…

view full answer...

Answer 7

Curt does indeed list their #C73DR as a fit for the 2020 Lexus RX350 as long as you do not have the F-Sport version. I have attached installation instructions for you to check out.

view full answer...

Answer 8

Out of the three hitches that are confirmed for your 2006 Lexus RX 330 The etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2 inch #e98857 is best because it has an extra coating of rust resistant paint on it making the…

view full answer...

Answer 9

The Curt Hitch #C13143 that you referenced will fit your 2013 Lexus RX350.The picture shows what the hitch will look like on the back of your vehicle - the receiver opening is about flush with the bumper. In the installation instructions that are…

view full answer...

Answer 10

It sounds like your 2009 Lexus RX 350 does not have the factory tow package. It may have the fuse in the fuse holder but the package was never installed. If that is the case then I recommend a wire harness like part #118478. This harness has a power…

view full answer...

Answer 11

The tie down brackets, if present, on the 2005 Toyota Highlander are bolted to the frame the same as the hitch gets bolted to the frame. They are not a load-bearing part of the vehicle and removing them will not compromise the vehicle at all. All…

view full answer...

Answer 12

The RX350 with the tow package is somewhat of a rarity. Since your Lexus has the wiring port in the rear driver's side cargo area, I would recommend using a circuit tester like part #PTW2993 and check to see if that port is active. Activate the…

view full answer...