Does the Awning Conversion Kit # LC329250 Install Over Manual Pull Out Arms

Question

Question:

when using this kit do you use the old pull out awning arms the rv is a 2000 Fleetwood discovery 36t the old awning is a AandE 9000 by dometic

asked by: Nathan S

0

Expert Reply:

Yes, the Solera Manual Pull Style to Power Awning Conversion Kit # LC329250 simply adds a motor to your current system. This is compatible with your AandE awning and will utilize the old arms to operate.

expert reply by: Jon G

0

Answer 1

Yes. You will use the existing arms when installing the Solera Conversion #LC329250 and the heads will be the primary part replaced on the awning. We do not have a video of this currently but the kit does come with detailed instructions to allow you…

view full answer...

Answer 2

You can use this #LC329250 conversion kit if you have a pull style manual awning. These Solera Kits are compatible with your Dometic awnings and everything you need is included with the kit. I've provided a video for you to check out!

view full answer...

Answer 3

I have an answer for you. I went ahead and called my contact at Lippert, and she confirmed that the Solera Manual Pull Style to Power Awning Conversion Kit #LC329250 works only with arms from Solera awnings. In order to know for sure if this will fit…

view full answer...

Answer 4

The awning arms are measured from top to bottom of the wall mount. This can then be used to select the correct length replacement. I have attached a photo below to assist. You will also need to pay attention to the style of arms such as pitched or…

view full answer...

Answer 5

The great thing about the Solera Manual Pull Style to Power Awning Conversion Kit #LC329250 that you referenced is that it can fit basically all styles and brands of awnings found on RVs. All you need is this kit and you'd be set.

view full answer...

Answer 6

To convert your Dometic manual awning to a power unit, you can use the Solera 12V Conversion Kit in Black #LC434723 or White #LC434724 if you have a manual crank system. These Solera kits are compatible with Dometic (A&E) awnings like what you…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

The correct replacement gear motor that replaces the Power Gear 1510000006 on your 2006 Fleetwood Fista is the Replacement PowerGear RV Above Floor Slide-Out Motor #LC368417. The Replacement Gear Motor #LC368193 you were looking at will not work…

view full answer...

Answer 12

To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…

view full answer...