UltraLube Biobased Moly EP Grease L10314 General Info

Question

Question:

Is there a spec sheet for the LubriMatic Moly EP Grease that I can use to compare it to other grease? We would be using this grease for a race car application. Thanks.

asked by: Bob S

0

Expert Reply:

The LubriMatic Moly EP Grease # LM54FR that you referenced is biobased with lithium thickener, molybdenum and an EP additive. Contains molybdenum disulfide to reduce friction and increase lubricity. Other useful info:

NLGI #2 LB
Drop point: 387 F
Drop-point values for UltraLube biobased products are slightly lower than the values of corresponding petroleum-based products. However, the reduced operating temperatures of biobased products compensate for the difference.

If you need further info let me know and I'll contact the manufacturer.

expert reply by: Jameson C

0

Answer 1

You are correct that in the Blue Ox SwayPro Owner&#39;s Manual they do recommend use molybdenum grease on both the hitch ball and the spring bars. The LubriMatic Moly EP Grease #LM54FR in a grease gun, such as #L30480, will work well. You…

view full answer...

Answer 2

From the base of the #C40047 up to the top of the ball measures 4.091 inches. This is about 1-3/8 inches taller than a standard ball.

view full answer...

Answer 3

The part #LM54FR that you referenced would work well for you. This grease contains molybdenum disulfide (often refered to as "moly") for better performance than general-purpose grease when metal parts are under high loads or…

view full answer...

Answer 4

Blue Ox recommends LubriMatic Moly EP Grease for the Blue Ox Sway Pro System. For that you would want the part #LM54FR. If you need a grease gun for that you would also need the part #L30200. I have linked both parts mentioned above to this page…

view full answer...

Answer 5

Yes, check out the Hopkins 6 Pole to 7 Pole Adapter part #47435. This is an adapter that will go from a 6-way to a 7-way.

view full answer...

Answer 6

Yes, it is recommended to lubricate the inner legs on the Blue Ox Aladdin tow bar to make sure they stay in good working order. Use a silicone based lubricant and NOT a petroleum based one like WD40. The other joints use self-lubricating washers.…

view full answer...

Answer 7

Yes, the UltraLube Biobased Moly EP Grease part #LM54FR is a molybdenum based grease so it will work with the Blue Ox Sway Pro Weight Distribution Systems like part #BXW1500.

view full answer...

Answer 8

Gladly! The difference between the Blue Ox Patriot 3 Radio Frequency, Portable Braking System BRK2019 and the Blue Ox Patriot Radio Frequency, Portable Braking System #BLU37TR is that the Blue Ox Patriot 3 RBRK2019 is older, no longer available,…

view full answer...

Answer 9

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...