What is the Width of Curt Trailer Hitch # C13902

Question

Question:

How wide is this hitch.

asked by: Bill R

0

Expert Reply:

I spoke with my contact at Curt about hitch # C13902. The overall width is approximately 41-1/2 inches. The bolt holes are approximately 39-1/2 inches apart on center.

expert reply by: Michael H

0

Answer 1

I have a solution for you, but the Curt Class III Trailer Hitch, #C13029, that you referenced will not fit the 1997 Chevrolet K1500 truck. If your truck has the standard or step bumper, then the Curt Class III Trailer Receiver Hitch, #C13042, will…

view full answer...

Answer 2

We have hitches that fit your 1985 Chevy C10 that has a deep bumper with the Curt hitch part #C13099. Your setup would definitely not be too low to tow with. A rise ball mount would make up for a lower hitch as well. I attached a help article

view full answer...

Answer 3

The Draw Tite hitch part #41524 is a confirmed fit for a replacement for your 1995 Chevy K1500 pick up truck.

view full answer...

Answer 4

The Draw Tite Class III hitch part #75033 that you referenced does fit your 1989 Chevy K1500 with the 37 inch frame dimension and step bumper.

view full answer...

Answer 5

I have a solution for you, but the Curt Multi-Fit Hitch #C13900 is not a confirmed fit on your 1992 F-150. If you have a standard bumper on your F-150 you can use the Curt #14001 and if you've got a deep-drop bumper you'll want to use the…

view full answer...

Answer 6

The best way to tell if your 1989 Chevrolet K1500 is a Heavy-Duty (HD) or Light-Duty (LD) version would be to obtain your VIN and call the dealer as they would be able to tell you whether or not you have the HD or LD version. Another way to tell if…

view full answer...

Answer 7

I attached a picture that has all of the dimensions of the Curt trailer hitch part #13573 that you referenced. I also attached an install video for you to check out as well.

view full answer...

Answer 8

The best option for a trailer hitch receiver on your 1989 Chevy K2500 long bed is the Draw-Tite Max-E-Loader Trailer Hitch Receiver #41524. I like this one because it is designed as a custom fit for your truck and the cross tube is mostly hidden. It…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...