Can the Head of the Cyclone RV Plumbing Vent Part # CAM40597 Be Removed

Question

Question:

Camco vent Is it possible to separate top to allow for winter storage cover

asked by: Bob

0

Expert Reply:

I do have options for you but I called my contact at Camco and they told me that the top part on the Cyclone RV Plumbing Vent part # CAM40597 that rotates is not designed to be removed. I went out to our warehouse and tested this myself to confirm that the rotating head cannot be removed and put back on. If you are looking for a lower profile vent I recommend the Camco RV Replacement Plumbing Vent part # CAM40033 which comes with both the putty and screws needed for installation. We also have a similar powered version of this vent that has a fan and for that you would need to use part # UF53-945001.

expert reply by: Conner L

0

Answer 1

The main piece that attaches to the pipe is what gets screwed onto the pipe using the 3 included self-tapping screws. So you would insert the Cyclone RV Plumbing Vent #CAM40597 into the existing pipe on the roof and then use the screws through it and…

view full answer...

Answer 2

The Valterra Plumbing Roof Vent #VA97ZR has a polypropylene construction. This is a thermoplastic polymer which is basically a fancy way of saying that it's essentially plastic.

view full answer...

Answer 3

You would have to come up with a way to plug the CAM40597 when you didn't want it to be active. It's initial design is for venting plumbing so it doesn't have any type of on/off setting. It shouldn't pull in rain but if an insect…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 7

Hey Clint, you are going to be installing the rail kit on the truck as well, correct? The Demco Recon 5th Wheel Trailer Hitch #DM47YV by itself should take only about 30 mins to assemble and install. The Installation Rail Kit #DM8551000 will also…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one that's slightly loose than one that tears…

view full answer...

Answer 10

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

view full answer...

Answer 11

Hey Rodney, thanks for reaching out! The Correct Track kits for Single #LC87120, Tandem #RR23QX, and Triple #RR55QX axle trailers are a solid choice to add up to 2" of lift to any standard axle setup. If that's what you have on your 2008…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Can the Head of the Cyclone RV Plumbing Vent Part # CAM40597 Be Removed

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching