Are All Optronics Lights Covered by Warranty?

Question

Question:

Are all your optronics lights covered by the lifetime warranty? Also can you give me more info on the lifetime warranty.

asked by: Jamar T

1

Helpful Expert Reply:

All Optronics LED lights, such as Tail Lights # TLL12RK are covered by a lifetime warranty. The warranty states that that they will replace the lamp if even a single diode fails. I have added a link to our selection of Optronics LED lights for you to check out as well.

expert reply by: Kyle S

1

Answer 1

The Optronics LED Trailer Tail Light #STL88RCB that you referenced has a limited lifetime warranty on the diodes for if one of them were to fail.

view full answer...

Answer 2

Good question, and the limited lifetime warranty means that the warranty covers any workmanship or defect in materials as opposed to standard wear and tear for the etrailer Cargo Bag with Mounting Straps #e98990. So if there is any issue with the…

view full answer...

Answer 3

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

view full answer...

Answer 4

Did you pull any fuses or disconnect the battery before installing the Replacement Hydraulic Pump for Lippert Level Up Leveling Systems #LC58TF Vic? Have you tried unplugging and replugging the connector back in to see if a pin needed to be reseated?…

view full answer...

Answer 5

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 6

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 7

Your surge coupler will have either a sticker or an engraving on it, typically near where the coupler is located. If you can get me that information and what you're needing to replace on it I'd be more than happy to help you find what…

view full answer...

Answer 8

Past customers have told us the AL-KO 8460 uses inner bearing 25580 and outer bearing 15123, which would make the Timken Bearing Kit #TMK82VR the correct replacement bearing kit for that hub. If you are looking to replace the hub entirely the correct…

view full answer...

Answer 9

The Glo-Brite 9553 you have currently measures 6-1/2" x 2-1/4" x 2-1/4" so for an incandescent replacement option I recommend the Custer Trailer Tail Light - Submersible - Stop, Turn, Tail - Incandescent - Oval - Red Lens #G65R which…

view full answer...

Answer 10

The trailer tire and wheel combo to fit your 10K Dexter axle would be the Taskmaster Provider ST235/85R16 Trailer Tire with 16" Vesper Silver Dual Wheel, #TA45FR. This wheel can be used as either the inner or outer wheel of a dual-wheel setup.

view full answer...

Answer 11

It's definitely possible to upgrade a trailer's axle rating to a higher rating by just swapping the axles. To pick out the correct axle you'll need to measure the distance between the hub faces and the spring seat centers and you'll…

view full answer...

Answer 12

The best way to confirm the correct replacement wheel bearings and seals for your 1999 Magic Tilt boat trailer is to pull one of the hubs and note the inner and outer bearing numbers and seal number. You can then directly search on those part numbers…

view full answer...