Review of Optronics Trailer Lights - Submersible LED Stop Turn Tail Light - STL12RB Video

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

Our installer here will spray the light with some lubricant around where the light meets the grommet and then will use a screwdriver to pry the light out first, and then the grommet. If you check out the install video I attached you will see this…

I reached out to my contact at Camco regarding the Olympian Wave 3 Catalytic Safety Heater #CAM57331 and he said the heater requires at least 4" of clearance on each side and at least 30" of clearance from the front of the unit (where the…

If you will be permanently installing the Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 then you would need to run a hose from the heater to the propane manifold. I cannot recommend you tap or splice into an existing line. The fitting…

I went out to the warehouse to measure Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 and the unit no longer has the knobs and buttons on the front. The black knob is on the left side of the unit and the red switch is on the left side…

In regards to the Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs part #CAM57331, it must be used in a ventilated area per the manufacturer to prevent the build-up of gasses. That said, its not possible to give specifics on this as there…

In some instances the trailer will try to ground itself between the hitch ball and coupler if the trailer's own ground connection is weak or poor. The best solution is to re-establish the trailer's own ground connection. Find the…

A example of a conventional steel trailer wheel is Dexstar #AM20766. Modular wheels are simply trailer wheels that feature cosmetically-appealing holes rather than spokes or a solid inner surface. A good example of a modular trailer wheel would be…

The Optronics Fleet LED Trailer Tail Lights part #TLL12RK which install inside a 6-11/16" x 2-5/8" opening is the closest option we have for you and it comes with the needed grommet and pigtail for installation.

You will be able to replace the incandescent lights on your trailer with LED without a problem. Like you said, you can just take the old lights out and replace them with new lights. If the Miro-Flex LED Combination Trailer Tail Lights - Submersible…

I confirmed with my contact at Optronics that the reflector ring that you need for the LED Trailer Tail Light w/ Flange - Stop, Turn, Tail - Submersible #STL73RB is the Snap-on Reflector Ring for STL78RB Series LED Lights #A78RXB.

We do offer many high-efficiency LED-type trailer stop/turn/tail lights in the 6-1/2 x 2-1/4-inch size of the Optronics #ST70RBTK that you referenced. All can be seen on the linked page. All lights shown are submersible. You can choose from either…