How is Tune Level Selection for the Edge EZ, # EZD1000A

Question

Question:

how to set diffrent levels in more definition

asked by: Dylan S

0

Expert Reply:

The Edge EZ, # EZD1000A comes with a switch that allows you to pick which tune level you want. I attached a picture I took from the install instructions that shows where the switch selector is for you to check out.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 2

As long as your 2004 Dodge Ram 3500 has the 5.9L diesel engine and is in good running condition, you can certainly use the Edge EZ programmer, #EP30204, to help boost your horsepower and torque as well as improve your fuel economy. With the EZ you…

view full answer...

Answer 3

Yes, the Edge Insight CTS3 part #EP54FR is compatible with your 2018 Ram 2500 with a Cummins diesel.

view full answer...

Answer 4

Performance tuners like Edge's products store a vehicle's original factory tune inside their internal memory. This storage feature allows you to restore the factory tune by reinstalling that original file. The tuners that fit your 2001 Dodge…

view full answer...

Answer 5

I am not sure which wire or step of the installation process you are referring to but I will walk you through the entire process below for future reference. In order to install the Edge EZ for Dodge Cummins 5.9L part #EP30203 on your 2003 Dodge Ram…

view full answer...

Answer 6

The Edge EZ for Dodge Cummins 5.9L, 24V #EZD1000A does not require an OBD-II port to install, as you can see in the linked instructions; you will only need to plug the EZ connectors into the ECM Data Link connection and MAP sensor. This programmer is…

view full answer...

Answer 7

Yes there are three power levels that the EZ Edge Programmer part #EZD1000A provides. You can see the switch in the attached picture.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

How is Tune Level Selection for the Edge EZ, # EZD1000A

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching