PSI Rating for Trailer Wheel Valve Stem # AM20906

Question

Question:

Please your help with this item: AM20906 / TYRE INFLATION / QTY 3 EA We´ll appreciate your prompt response. Regards

asked by: MIGUEL R

0

Expert Reply:

The valve stem part # AM20906 that you referenced has an air pressure rating of 100 psi and can fit valve stem rim holes that are .453 or .625 inch.

I attached a review video for this valve stem for you to check out as well.

expert reply by: Jameson C

0

Answer 1

It would not be necessary to use Loctite on Americana valve stem #AM20906. You will need to be sure to torque it properly, which is recommended to be between 25 and 55 inch-pounds. And in regards to your second question, you are correct about the…

view full answer...

Answer 2

To tighten the stem you will need to tighten it down until the rubber grommet flattens out to where it is flush with the washer provided with the valve stem. This will create a good seal without over-tightening the rubber grommet. Once it is…

view full answer...

Answer 3

We have the Americana valve stem part #AM20906 which is a metal valve stem that fits valve stem hole in trailer wheels that are either .453 and .625 inch. These two sizes basically cover all trailer wheels. The valve stem can also handle over 100 psi…

view full answer...

Answer 4

It sounds like you're looking for the Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheel - 15" x 6" Rim - 5 on 4-1/2 #AM22627 instead of the #AM22646. These wheels do have a 2150-lbs per wheel capacity, like you mentioned. These wheels do…

view full answer...

Answer 5

In regards to a trailer wheel and tire assembly, the psi rating comes from the trailer tire and valve stem. Therefore, if the psi rating of the valve stem exceeds that of the trailer tire you will not have any issues. The trailer wheel itself does…

view full answer...

Answer 6

Yes, the Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheel #AM22627 will work with the Transeagle ST Radial Premium Trailer Radial Tires-ST225/75R15.

view full answer...

Answer 7

The HWT Aluminum Hi-Spec Series LW Trailer Wheels do not have a max psi rating. The reason for this is because it does not come with a valve stem and that is what dictates your psi rating. The Americana Metal Bolt-In Valve Stem part #AM20906 is what…

view full answer...

Answer 8

The Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheel #AM22627 that you referenced has a zero offset and a backspacing of 3-1/2 inches.

view full answer...

Answer 9

view full answer...

Answer 10

I went out to the warehouse and pulled an Americana Trailer Wheel Center Cap, #AM90175, to determine the finish that is on it. Though in the pictures it looks dull, the cap is actually shiny, you can see yourself clearly but it is not as brilliant as…

view full answer...

Answer 11

Yes, your Dexstar wheel can handle the 80 psi requirement of your new tires. If there was anything in your tire/wheel setup that might not handle 80 psi it would actually be the valve stems which you could pretty easily swap with the part #AM20906…

view full answer...

Answer 12

The Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheel part #AM22327 does not include a center cap. The pilot hole size is 3.19". I recommend to use Americana Trailer Wheel Center Cap - Stainless Steel - 3.19" Pilot part #AM90175 which is…

view full answer...