Is U-Bolt from Reese Chain Kit # 55630 the same Size as U-Bolt from the Reese Chain Kit # 3216

Question

Question:

I was wondering if the Drawtite 3216 had the same size ubolts as the Reese 55630. I like the Drawtite kit better and looks like a better value. Thanks.

asked by: Bill

0

Expert Reply:

Yes, the u-bolts from the Reese Replacement Chain Kit # 55630 are the same size as the Reese Replacement Weight Distribution Chain Kit # 3216.

Both of the u-bolt sizes are 3/8 inch.

expert reply by: Jameson C

0

Answer 1

Replacement chains #C17111 are designed as replacements for Curt weight distribution systems with ratings up to 1,500 pounds tongue weight. They will work with other systems as long as those systems accept 3/8 inch u-bolts at the ends of the bars.

view full answer...

Answer 2

Since your Reese weight distribution system is rated for 15,000 pounds I recommend getting 2 of heavy duty lift bracket #58392. For a chain kit use #3216. You would only need 1 chain kit.

view full answer...

Answer 3

The chains in the Reese Strait-Line Hitch with Shank 1,200 lbs. TW / 12,000 lbs. GTW, item #RP66084, are designed to be used with weight distribution systems up to 12,000 pounds gross trailer weight and 1,200 pounds tongue weight. These chains can be…

view full answer...

Answer 4

Each of the two 9-link chains included in the Reese Replacement Weight Distribution Chain Kit #3216 measures 13-inches tip to tip. Reese no longer makes an 11-link replacement chain, but you can use the Curt #C17111 kit.

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Is U-Bolt from Reese Chain Kit # 55630 the same Size as U-Bolt from the Reese Chain Kit # 3216

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching