Length of Chains in Reese Replacement Weight Distribution Chain Kit 3216

Question

Question:

My current chain has 11 links. I plan to replace 800 lb bar with 1200 lb bar. I will need 11 links. I use 10 links with the 800 lb bar. How long is the chain in the chain sets.

asked by: Daniel L

0

Expert Reply:

Each of the two 9-link chains included in the Reese Replacement Weight Distribution Chain Kit # 3216 measures 13-inches tip to tip. Reese no longer makes an 11-link replacement chain, but you can use the Curt # C17111 kit.

expert reply by: Adam R

0

Answer 1

The extra bracing on the sides of the receiver tube on the OEM hitch on your 2012 Silverado 2500 HD causes most standard hitch locks to be too short to work. We found this out early on and inquired with our hitch lock manufacturers about a locking…

view full answer...

Answer 2

The u-bolts included with #RP58032 are 3/8 inches in diameter. The threaded part has 16 threads per inch. This kit is specific to Reese and Pro-Series chain hanging weight distribution systems so if that is what you have then this is the correct kit.…

view full answer...

Answer 3

You would not want to tighten the nuts of the Curt Weight Distribution Replacement Lift Chain U-Bolts part #C17111 to the point that the link isn't able to move anymore. You will want to allow the chain to move in the U-bolt. The reason the nuts…

view full answer...

Answer 4

Typically when the frame brackets for the Reese Weight Distribution #RP66020 can't be used they switch to the Bolt On Hangers #RP58305. I have seen some weld the brackets onto the trailer but as Reese did not design the brackets to be used in…

view full answer...

Answer 5

The chains in the Reese Strait-Line Hitch with Shank 1,200 lbs. TW / 12,000 lbs. GTW, item #RP66084, are designed to be used with weight distribution systems up to 12,000 pounds gross trailer weight and 1,200 pounds tongue weight. These chains can be…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Length of Chains in Reese Replacement Weight Distribution Chain Kit 3216

Products Referenced in This Question

Continue Researching