Replacement 3-Speed Fan Switch for Fantastic Vent RV Vent

Question

Question:

I have the manual model version and need a speed switch burned out after a year in brand new trailer. Will this fit

asked by: Brian H

0

Expert Reply:

The replacement part you referenced, Replacement 3-Speed Switch for Fan-Tastic Vent Roof Vents # FVK1031-05, is the correct part for your Fantastic Vent RV Vent.

expert reply by: Adam R

0

Answer 1

If you for sure used a 3 speed switch like the #FVK1031-05 as a replacement switch it would appear that the wiring of the switch might be messed up. I'd check that to see if that allows the different speeds to function again. I attached a diagram…

view full answer...

Answer 2

The 3 speed switch/controller part #FVK1031-05 that you referenced is the correct replacement for your Fan-Tastic vent model 6504/414 or 6504r/414. Based on what I was able to find on the numbers you listed the fan you have is the #FV803350 which the…

view full answer...

Answer 3

If you have a circuit tester like part #PTW2993 you could test the wires of the switch as you switch between them. If you can't get voltage on the pins that run from it to the motor in any of the positions you need a switch like the #FVK1031-05.…

view full answer...

Answer 4

If you need to replace the speed switch for the Fan-Tastic Vent Roof Vent FV801250 then you are needing part #FVK1031-05. Attached are some review videos for you to check out.

view full answer...

Answer 5

Fantastic Vent does not offer a kit to convert a remote-controlled vent to a manual one so I recommend replacing the unit. This will be both safer and easier. We have models like #FV801208 that includes a manual knob for opening and closing the lid…

view full answer...

Answer 6

You can trace the connectors you have on your fan assembly to determine where they terminate in order to install the new switch #FVK1031-05. Why your old switch had only 2 of them connected I can't say unless it did not have all the functions…

view full answer...

Answer 7

I have attached for you below a few wiring diagrams for the Dometic DV4100 Roof Vent Fan which I have received from the manufacturer directly.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

The Hollywood Racks Destination E Bike Rack for 2 Electric Bikes part #HLY66ZR is compatible with a swing-away adapter such as the Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks part #PVD20B. That said, your capacity may be reduced with the…

view full answer...

Replacement 3-Speed Fan Switch for Fantastic Vent RV Vent

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching