Diameter of Replacement Handle Rod # SJ-100-HD

Question

Question:

What is diameter of the end of the bar??

asked by: Mike H

0

Expert Reply:

The diameter of the Replacement Handle Rod # SJ-100-HD you referenced is 1/2 inch.

expert reply by: Jameson C

0

Answer 1

Typically you mount stabilizer jacks like Item #TJ01RT under the corners of your camper. These jacks have a 650-lb capacity, are sold individually, and are designed to keep your camper level and steady. They have a bolt-on or weld-on installation…

view full answer...

Answer 2

The stabilizer jack I recommend for your enclosed cargo trailer is the Drop Leg Stabilizer Jack #TJ01RT because it will work well to stabilize your trailer for loading and unloading and is easy to engage when needed. The #TJ01RT drop leg stabilizer…

view full answer...

Answer 3

Most likely it would work fine. Most of these are 1/2 inch in diameter like the part #SJ-100-HD that you referenced. If yours needs a 1/2 inch diameter rod this would work well.

view full answer...

Answer 4

It should fit perfectly, but because the Atwood jack has been discontinued for awhile and I can't confirm it for myself I'd recommend simply measuring the diameter of the hole in the assembly where the jack handle installs. If that hole…

view full answer...

Answer 5

The length of the Replacement Handle Rod #SJ-100-HD is 11-3/4 inches.

view full answer...

Answer 6

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Diameter of Replacement Handle Rod # SJ-100-HD

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching