Obtaining Brake Stop Light Signal to Install Brake Controller in 2003 Subaru Forester
Question:
Im wiring one of your flat 4 pin to 7 pin round connector kits, and using a Tekonsha Primus, and installing on a Subaru Forester. Id rather not splice into the brake switch wiring. Can I splice into the brake light wire on the 4-pin connector and run a wire alongside the grey wire thats coming up from the rear and connecting to the battery, and use that as the source of brake signal for the controller? thanks
asked by: Steve
Expert Reply:
The circuits for the brake light signal on the 4-pole connector is also combined with the turn signals. If attached in this manner, the brake controller could apply the trailer brakes when the turn signals are activated.
As an alternate, the brake controller can obtain its brake light signal from one of the brake lamps, but I would strongly suggest installing the controller as the manufacturer recommends, by using the wire at the brake stoplight switch. Thousands of brake controllers have been installed in this manner over the years, and this method of obtaining the brake signal has proven to be very reliable.
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Review of etrailer - Brake Controller - ETBC7
- Video: Review of Tow Ready No Drill Mount Bracket - 18136
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: No-Drill Mount Bracket, Long
- Shop: 12 Gauge Black Primary Wire - per foot
- Shop: Extension Cable for Hopkins Smart Hitch Backup Camera - 5 ft
- Shop: Mighty Cord Universal 7-Way Mounting Bracket
- Shop: Deka Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 1
- Shop: Ring Terminal - 12-10 Gauge Wire - 3/16" Ring ID
- Search Results: backup camera
- Search Results: 12 gauge wire
- Search Results: 44~5310a
- Search Results: no drill mount bracket
- Search Results: bracket for 7 way
- Search Results: adapter
- Search Results: hm50002
- Shop: Brake Controller
- Shop: Trailer Wiring
- Q&A: Finding Stoplight Circuit for Brake Controller Install Ford Dump Truck
- Q&A: Trouble Finding Brake Switch Wire to Install Brake Controller on a 2006 Toyota Tundra
- Q&A: Alternative Location for Brake Controller Red Wire on a 2012 Chevy Express Van
- Q&A: Which Brake Switch Wire is the Right One on a 2008 Chevy Express Van to Install a Brake Controller
- Q&A: Does a Brake Controller Red Wire Have to Attach to the Brake Switch on a Vehicle
- Q&A: Do Proportional Brake Controller Require Tapping into Stoplight Circuit of Brake Pedal Switch
- Q&A: How to Find the Brake Switch Stop Light Wire on a 2006 Nissan Pathfinder
- Video: Roadmaster Universal Stop Light Switch Kit Instalaltion - 2021 Chevrolet Trailblazer
- Shop: Vehicle Tow Bar Brake System
- Article: Brake Controller Installation: Starting from Scratch
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)