Trouble Finding Brake Switch Wire to Install Brake Controller on a 2006 Toyota Tundra
Question:
I have followed instructions for 2002 Tundra, I have a 06, I cant get tester to light up on any of the four wires at brake switch above brake pedal so I can find brake signal wire. I tried another tester, tested tester and it works fine. I have connected the alligator clip to wires and used metal point to ground and vice versa, any suggestions........???
asked by: Arnold K
Expert Reply:
Some times the truck has to be turned on for there to be power on the correct brake switch wire. If the brake lights do not light up unless the truck is on then turn the truck on and then test the brake switch wires.
Usually circuit testers don't need a substantial ground but that could be the issue too. You need a bare metal steel surface. No paint or aluminum. If you have the white brake controller wire attached to the negative battery terminal then you should be able to temporarily attach the tester ground to it.
I have linked a video that might help but the wire colors may not be the same between a 2002 and a 2006.
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Review of Tow Ready No Drill Mount Bracket - 18136
- Video: Review of etrailer - Brake Controller - ETBC7
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: No-Drill Mount Bracket, Long
- Shop: 12 Gauge Black Primary Wire - per foot
- Shop: Ring Terminal - 12-10 Gauge Wire - 3/16" Ring ID
- Shop: Deka Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 1
- Shop: Mighty Cord Universal 7-Way Mounting Bracket
- Shop: Extension Cable for Hopkins Smart Hitch Backup Camera - 5 ft
- Search Results: backup camera
- Search Results: dw05745
- Search Results: no drill mount bracket
- Search Results: adapter
- Search Results: 12 gauge wire
- Search Results: bracket for 7 way
- Search Results: hm50002
- Shop: Brake Controller
- Shop: Trailer Wiring
- Q&A: Finding Stoplight Circuit for Brake Controller Install Ford Dump Truck
- Q&A: Alternative Location for Brake Controller Red Wire on a 2012 Chevy Express Van
- Q&A: How to Find the Brake Switch Stop Light Wire on a 2006 Nissan Pathfinder
- Q&A: Which Brake Switch Wire is the Right One on a 2008 Chevy Express Van to Install a Brake Controller
- Q&A: 2 Brake Switch Wires have Power with Brake Pedal on a 2016 Ford Escape
- Q&A: Obtaining Brake Stop Light Signal to Install Brake Controller in 2003 Subaru Forester
- Q&A: Do Proportional Brake Controller Require Tapping into Stoplight Circuit of Brake Pedal Switch
- Video: Roadmaster Universal Stop Light Switch Kit Instalaltion - 2021 Chevrolet Trailblazer
- Shop: Vehicle Tow Bar Brake System
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring