What Is The Cost For Hopkins Adapter 4-Way to 7-Way and 4-Way # 37185

Question

Question:

the seven way conector with the 4 way flat that you use on this kit

asked by: Daniel

0

Expert Reply:

The adapter that is used in the # ETBC7 and plugs into the vehicle 4-way to provide both a 4-way and a 7-way connector is part # 37185. I have attached a link to an installation video for this connector. The prices for the products we offer are shown on the product page.

expert reply by: Jeffrey L

0

Answer 1

To address your first question about the capacity's of the Curt Hitch #13534 and your 2010 Toyota Highlander you must always go with the lowest rated component in a towing setup as the overall towing capacity. So since your vehicle is rated at…

view full answer...

Answer 2

You can use #37185 to replace the damaged parts from your #ETBC7 kit. You might also be interested in a backup camera such as #HM50002 if the nature of the incident was related to backing up.

view full answer...

Answer 3

I reached out to my tech contact at Hopkins and the wire gauges for the Hopkins Endurance 7-Way Trailer Connector with Universal Pigtail Harness #HM47210 are as follows: Red, Black, and Blue--14 gauge White--12 gauge Purple, Yellow, Green and…

view full answer...

Answer 4

Hey Franco, we have an easy solution to provide a stoplight circuit on your dump truck with the Roadmaster Universal Stop Light Switch Kit #RM-751000. Some vehicles have a hard time finding the stoplight circuit but this switch solves the problem.

view full answer...

Answer 5

The circuit tester of the Universal Installation Kit for Trailer Brake Controller #ETBC7 doesn't have exact instructions so I can understand not knowing how to use it if you hadn't had previous experience. But all you have to do is attach the…

view full answer...

Answer 6

Your Explorer will not have the brake controller wiring unless it has the 7 way connector on the bumper. Since you have the 4 way, you would need to use the Brake controller installation kit, part #ETBC7. The kit would actually contain the 4 to 7 way…

view full answer...

Answer 7

Some times the truck has to be turned on for there to be power on the correct brake switch wire. If the brake lights do not light up unless the truck is on then turn the truck on and then test the brake switch wires. Usually circuit testers don't…

view full answer...

Answer 8

Test both of the wires with the head lights or turn signal on. If one has power during this test and the other does not then use the one that DOES NOT have power when the head lights or turn signal on to install a brake controller in your 2016 Ford…

view full answer...

Answer 9

The brake controller red wire requires a connection to a dedicated brake light only circuit. If anything else is on that circuit, such as a turn signal on vehicles that have combined brake and turn signals, then that circuit cannot be used. You…

view full answer...

Answer 10

On a 2008 Chevy Express Van the wire on the brake switch you need should be a white wire but it could also be a light blue wire with a white strip. That is the correct wire from the cold side of the brake switch. The vehicle key will have to be on…

view full answer...

Answer 11

Yes, all brake controllers require you to tap into the brake pedal circuit. The reason is that the controller needs to know when to start looking for braking deceleration and start applying the brakes. If the sensor was always active and looking to…

view full answer...

Answer 12

The circuits for the brake light signal on the 4-pole connector is also combined with the turn signals. If attached in this manner, the brake controller could apply the trailer brakes when the turn signals are activated. As an alternate, the brake…

view full answer...

What Is The Cost For Hopkins Adapter 4-Way to 7-Way and 4-Way # 37185

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching