Are Replacement Bolts Available for Ultra-Fab Micro-Rollers?

Question

Question:

Ultra-Fab Steel Micro-Roller for Trailers and RVs - Weld On - 2inch Wide x 2-1/4inch Tall Item # UF48-979021 Do you have a replacement bolt for this product? I’ve got 4 of these and the bolt broke on one of the rollers.

asked by: Todd S

0

Expert Reply:

Replacement bolts are not available for the Ultra-Fab Steel Micro-Roller # UF48-979021, you would need to replace the roller itself.

expert reply by: Kyle S

0

Answer 1

When power appears on a vehicle's trailer wiring when it should not the reason is usually a short or corrosion. The short-circuit or corrosion can let power from one circuit bleed over to another. Sometimes you can see the problem at the…

view full answer...

Answer 2

When choosing skid wheels you want to try to find some that won't reduce your ground clearance too much. Motorhomes typically use the larger skid wheels like the Ultra-Fab #UF48-979014 while shorter skid wheels like the Ultra-Fab #UF48-979021…

view full answer...

Answer 3

I may have a solution for you, but the part #UF48-979020 that you referenced is designed to attach to the bottom of a 2 inch hitch opening so it wouldn't be a great solution for you. A weld on roller like part #UF48-979021 might be a better…

view full answer...

Answer 4

Thank you for providing a photo diagram of your 5th wheel rear frame area where you are intending to install Ultra-Fab Steel Micro-Roller Skid Wheels #UF48-979021. The best location to weld on these rollers is at or just behind the point where the…

view full answer...

Answer 5

Often when a trailer harness lighting circuit stays on continuously, even when the vehicle lights are okay and function correctly, the issue is corrosion inside the vehicle socket or the trailer plug that allows the 12V auxiliary power signal to…

view full answer...

Answer 6

I spoke with my contact at Ultra-Fab about the grease fitting in the bolt on the Steel Micro-Roller #UF48-979021. She said that the design was changed a little over a year ago, changing the fitting from a press-in fitting to a screw-in fitting. My…

view full answer...

Answer 7

It is very unusual for 4-pole trailer wiring to get hot enough to melt the 4-pole plug. This wiring format carries only basic lighting signals, no trailer brake power, no reverse lights and no auxiliary 12V power. It would be much more common for an…

view full answer...

Answer 8

This is a two fold answer according to my technical contact at Ultra-Fab. If you happen to be turning at the same time you are backing up then you will want to go with the caster type wheels #UF48-979011 that you referenced. I do want to mention that…

view full answer...

Answer 9

There are two basic brake assembly sizes for most travel trailers the size of your 28 foot 1991 Fleetwood Terry Taurus Travel Trailer. The simplest way to know which one will work for your trailer is to look at the bolt pattern that attaches the…

view full answer...

Answer 10

It does sound like there is a possible short with the brake magnets on your trailer, especially if all the wiring looks good between the brake controller and vehicle connector. I recommend first making sure that each magnet has one wire secured to…

view full answer...

Answer 11

If your Tekonsha P3 Brake Controller, part #90195, displays the error message OUTPUT SHORTED NO BRAKES, the potential causes are a short in the brake output circuit somewhere between the brake controller and the trailer brake assemblies, or a shorted…

view full answer...

Answer 12

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...