Is the Weight Capacity of the Timbren Rear Suspension Enhancement System Per Spring or Per Axle

Question

Question:

Timbren see load capacity 2400 lb . Is that per spring or per axle?see above is ses. For Toyota sienna awd 2011

asked by: Marty

1

Helpful Expert Reply:

The 2,400 lb. load capacity of the Timbren Rear Suspension Enhancement System part # TTORSEN04 for your 2011 Toyota Sienna is per axle. You will not need to worry too much about this capacity as you will be well overloading the payload of your vehicle before this weight capacity is a factory.

The Timbrens are going to be the highest rated weight capacity we have in a suspension enhancement option for you at this time.

expert reply by: Conner L

1

Answer 1

For a camper trailer towed by a passenger van like your 2010 Toyota Sienna the best handling-enhancement item is usually going to be a weight distribution/sway control system, rather than a vehicle suspension enhancement kit. Weight distribution (WD)…

view full answer...

Answer 2

I have a solution for you, but the Timbren #TTORSEN04 are not going to significantly lift the rear end of your vehicle and really aren't intended for this purpose. These are designed for when you're towing a camper that has a heavier tongue…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 9

I do have an option for you but the Curt Trailer Hitch Receiver part #13390 on your 2015 Subaru Legacy already has the highest ground clearance (10-1/4") of any other trailer hitch receiver we have confirmed to fit your vehicle. This measurement…

view full answer...

Is the Weight Capacity of the Timbren Rear Suspension Enhancement System Per Spring or Per Axle

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching