Replacement Kwikee Step Frame Only for Series 32 RV Steps

Question

Question:

I have a Kwikee Products step S/N 148614. Series 32. Is this the replacement step only for this step? Just need the frame.

asked by: Ken H

0

Expert Reply:

The Lippert Components Kwikee Step Frame 32 SERIES DOUBLE STEP (908032000) # LC3722618 is just the frame and is the replacement part you are seeking for your Series 32 steps. It does not include the motor or control switch.

expert reply by: Jason S

0

Answer 1

Yes, the Kwikee motor kit from a 28 is the same as a 32 since the part #LC379145 is the kit for both so for just the frame you'd need the part #LC3722618 and it would fit your current motor.

view full answer...

Answer 2

It sounds like you're looking for the Replacement Gear Box and B Linkage for Kwikee Electric RV Steps #LC379161. This includes the gearbox and the linkage so you should be good to go for your Kwikee 28, 31, 37, or 39 steps!

view full answer...

Answer 3

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 4

The distance between the steps of the Lippert Kwikee 32 Series Electric Step #LC3722618 is 7 inches. I attached a picture that shows this dimension and the overall drop too.

view full answer...

Answer 5

Thanks for the picture and info from the double step you have on your Tiffin RV. Based on that the correct replacement is the #LC3722862. This will be an exact replacement so the install will be very easy!

view full answer...

Answer 6

On the same sticker that shows the serial number for your Kwikee steps there should also be a part number and a build date. For a 32 series the part number would be something like 903209025. In this number the 6th digit indicates the steps were built…

view full answer...

Answer 7

If you're having an issue with the steps fully extending and retracting then that points to the motor. The control box reads the motor's voltage to send the signal to stop the steps so if the motor is not working correctly it will arc out too…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Since you need the Replacement Control Unit for Kwikee 38 Series Electric RV Steps #LC363989 I'm assuming you have 38 series steps on your 2017 Thor Windsport. The correct replacement motor for these steps would be the #LC379147.

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement Kwikee Step Frame Only for Series 32 RV Steps

Product Page this Question was Asked From

Continue Researching