Does Curt Hitch C12115 Fit 2016 Buick LaCrosse with Dual Exhaust

Question

Question:

I am looking at buying C12115 to install on my 2016 Buick LaCrosse Sport Touring. The installation video shows installation on a LaCrosse with single exhaust - mine has dual exhaust. Will the kit have all the appropriate hardware? Additionally I do not have access to a hoist and will be doing the install with the car on jackstands - will this still be possible to do? Thanks

asked by: Ben

0

Expert Reply:

The Curt Hitch part # C12115 is a fit for your 2016 Buick LaCrosse with dual exhaust. We have confirmed this with our contacts at Curt.

All of the needed install hardware is included. You should have no problem using jack stands to install this hitch too. We use a lift for our installs mainly just to make the filming process easier.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 7

I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that 1-1/4…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Does Curt Hitch C12115 Fit 2016 Buick LaCrosse with Dual Exhaust

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching