Will Curt Trailer Wiring Harness # 55323 Fit 2004 Dodge Dakota

Question

Question:

your website states that part # 55323 will fit my 2004 Dodge Dakota but if you go to the Curt website it states it does NOT fit.

asked by: Mike

0

Expert Reply:

Sometimes Curt's online fitguides can be confusing. I did just check their most recent fit chart and the # 55323 is listed as a confirmed fit for your 2004 Dodge Dakota so it will fit and work well.

expert reply by: Jameson C

0

Answer 1

If your 2004 Dodge Dakota has a factory 7-way the trailer wiring harness part #C55381 would fit and work well to provide you with a 4-way. If instead you did not have a 7-way you would want the part #55323 which plugs inline with the taillight…

view full answer...

Answer 2

Good news! You are on the right track to equip your 2004 Dodge Dakota Quad Cab with wiring to tow. Since your Dakota doesn't have the tow package then yes, you will need the 4-way wiring #55323 first, this will simply plug and play with…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 11

It is very easy, as you just use the included clamps to secure the Caprock to your roof rack crossbars. The clamps are secured to the channels under the platform, and can be positioned wherever needed to accommodate the spacing of your crossbars.…

view full answer...