Trailer Fenders to Fit Kenda 5.70-8 Bias Trailer Tire with 8-inch White Wheel AM30120

Question

Question:

ask about a tires and fender with a backtire 5.70-8 trailer tire, am 30120 and a fender to fit

asked by: Paul

0

Expert Reply:

The Kenda 5.70-8 Bias Trailer Tire with 8-inch White Wheel # AM30120 has an overall diameter of just over 18-inches so for a fender you will want to use one of those shown on the linked page. These fenders fit this 8-inch size trailer wheel.

You have choices in aluminum, plastic and steel fenders such as black plastic fender with step # F008559.

I also linked all of our fender mounting brackets.

expert reply by: Adam R

0

Answer 1

Wow, your truck must have quite a lift and the trailer coupler height must be super-low! 4 inches of ground clearance under the hitch ball isn't sufficient. There are things you can do with the suspension on the trailer to raise its height.…

view full answer...

Answer 2

Yes when you do an over-under kit you have to weld the seats to the axle for it to be installed properly. It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...