LED Strip Light with Black Housing

Question

Question:

I would like 4 of these in BLACK ILL70CBAWN.

asked by: Charles

0

Expert Reply:

For an LED-type strip light with a black housing you can use Opti-Brite RV Interior Strip Light # ILL70CBSBAWN. This light features a tough polycarbonate housing and lens and high-efficiency LEDs for brighter output on less power.

expert reply by: Adam R

0

Answer 1

The Optronics Opti-Brite RV Interior Strip Light #ILL70CBSBAWN referenced in your question is without a doubt, a very cool light assembly that would look great on an RV porch. While this unit is not necessarily designed as an outdoor light, it does…

view full answer...

Answer 2

If you have a Curt Weight Distribution System with chains such as #C17063, there should not be grinding noises when turning coming from the chains and this can be adjusted by switching the links in the lift chains. You can adjust the head tilt for…

view full answer...

Answer 3

If you have the spring bar tension set up too high you can see ride issues. Typically it's a very harsh ride quality but sway is possible too. The best way to pick out a weight distribution system is to base it off of the loaded tongue weight…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 8

According to RoadActive Suspension the spring rate for the standard kit #RAS3611-S is 2,400 lbs. For the heavy duty #RAS3611-SHD it is 3,600 lbs. The heavy duty #RAS3611-SLHD is the same but only designed to fit if you have factory top overload…

view full answer...

Answer 9

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 10

Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch being the following: - B&W Continuum Weight…

view full answer...

Answer 11

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...