Replace your old and worn out weather stripping around doors and hatches of your RV before water damage creates a costly headache. Adhesive backing is pre-applied for an easy DIY install.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody. Andy here with etrailer.com. And today, we're gonna take a look at this rubber rectangle round edge seal for RV and trailers. With this rubber seal, you are going to be able to replace your old and worn out weather stripping around your doors and hatches of your RV before water damage creates a costly headache for you. Now, this is a peel and stick installation with the pre-applied 3M adhesive backing. You simply remove the backing and apply the seal to your frame.
Surface preparation is recommended to remove any old adhesive. And just use a pair of scissors to trim the extra seal that you do not need. This is made in the USA of EPDM dense rubber that won't shrink, crack or fade over time. It's a very durable feeling and I believe it's gonna be long-lasting. It is also resistant to UV damage.
Now, this is a 10 foot long strip. And let me retrieve my ruler here and give you some additional measurements that might prove helpful for you. Looking at the width, we're sitting at what looks to be 11/16 of an inch wide. And then looks like about 7/16 of an inch tall. And that is going to conclude our brief look today.
I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.