Does the Solera 13.5' Slider (Slide-Topper) Include the Awning Rail

Question

Question:

If this 13.5inch slider is sold without the awning rails, how does one procure them and how much extra do they cost?? The price doesnt seem to reflect any reduction due to the rails not being included.

asked by: Ken C

1

Helpful Expert Reply:

According to Lippert/Solera, Solera 13.5' Slider (Slide-Topper) # LCV000168109 does include the awning rail. I have included a link to a video showing an example installation for you.

expert reply by: Michael H

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...

Answer 4

Solera recently decided to start including awning rails with their slide toppers.

view full answer...

Answer 5

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 6

Those are good questions. We would first want to confirm the specific model of Ram truck you have. The towing/pin weight capacities can vary between different model. Your owners manual should also specify the towing capacity and pin weight capacity.…

view full answer...

Answer 7

It's not uncommon to have a slide topper installed below the awning of the RV if the awning happens to be over the slide out. As long as you have room for a rail to fit under the main awning rail this would be totally fine. To pick out the…

view full answer...

Answer 8

Hi Donald, For a 150" flange to flange measurement you'll need the Solera RV Slide-Out Awning #LCV000163299. This slide topper is designed to fit 146" - 151" flange to flange measurements. Going a size larger than this could…

view full answer...

Answer 9

If you have an older style Solera awning we currently offer the following replacement components: Replacement Bracket Kit for 2019 - 2022 Solera RV Slide-Out Awnings - Black #LC795354 Replacement Bracket for pre-2019 Solera RV Slide-Out Awnings -…

view full answer...

Answer 10

Since we know your slide out flange measurement is 153 inches from flange to flange the correct slide out awning would be the part #LCV000168109 for black or part #LCV000163300 for white.

view full answer...