Slide Out Awning for Slide Out with 153 inch Flange Dimension

Question

Question:

Needing awning that fits slide out flange to flange is 153 inches

asked by: Tony

0

Expert Reply:

Since we know your slide out flange measurement is 153 inches from flange to flange the correct slide out awning would be the part # LCV000168109 for black or part # LCV000163300 for white.

expert reply by: Jameson C

0

Answer 1

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 2

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 3

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 4

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 5

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 6

Your 13-10 equalizers, which should be equivalent to Equalizer #TREQ310 measures 6-1/16 inches from bolt hole to bolt hole (see accompanying photo) and due to that you will need to use the E-Z Flex Heavy Duty Rubber Suspension System #K71-652-00.…

view full answer...

Answer 7

I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…

view full answer...

Answer 8

I recommend the Solera RV Slide-Out Awning - 13'1" Wide - 48" Projection #LCV000168109 which will fit RV's with slide outs that are 152" to 157" wide and up to 48" long, the awning rail is included. This is also…

view full answer...

Answer 9

If your rear indicators are not working, it's almost certainly a poor ground, so the first thing to do is take a look at your ground connections to make sure they are attached to bare metal surfaces and free of any paint, dirt or corrosion. What…

view full answer...

Answer 10

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

view full answer...

Answer 11

Based on my research, it looks like the part 725-0021 is a single step electric Coachstep, and we do have the correct replacement motor, which is the following part: - Replacement Motor for Lippert Electric Coachstep #LC301695 I verified with the…

view full answer...

Slide Out Awning for Slide Out with 153 inch Flange Dimension

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching