Would Optronics Light STL72RB Fit as Replacement for Command Electronic 003-5400

Question

Question:

i have a Command Electronic Stop,Tail, and Turn model #003-5400 light for my horse trailer. i am looking to replace it with your STL72RB. Size matches up per your specs but i just wanted to ask for sure. The rubber grommet is good on the trailer and the harness looks like a match. Thanks for your help.

asked by: Davis S

1

Helpful Expert Reply:

The Optronics light part # STL72RB is made to fit a standard trailer light dimension so it makes sense that it would fit and work for your setup.

I attached a picture that has the light dimensions for you to check to see if they match.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The Command 003-5400 light doesn't give me specific dimensions. Base on some research it appears the Optronics #STL72RB may be a replacement option. I've attached the measurements for this light to assist. The Optronics #STL22RB is a similar…

view full answer...

Answer 2

I spoke with my contact at Optronics and was informed that the Lumen Difference between the #STL22RB and the #STL72RB LED tail lights is not tested by Optronics. I was told though that the more LED lights that are in the tail light the brighter the…

view full answer...

Answer 3

Yes, this could possible be an issue. Sometimes a faulty ground can limit the amount of current that can flow to the lights. It can also cause your lights to behave in unpredictable ways. My recommendation would be to hook up a 12V, well charged,…

view full answer...

Answer 4

Running a direct ground up to the trailer tongue or junction box would certainly work, but the only time I'd see that as being necessary is if the lamps were connected to a non metallic structure or a metallic structure that wasn't directly…

view full answer...

Answer 5

We have a large selection of LED trailer lights which I have attached for you. You will need to go through these and pick the one that best matches your existing lights. You could also provide me with a dimensional photo to which I could then search…

view full answer...

Answer 6

view full answer...

Answer 7

There are a couple of possible reasons why the directional lights on your trailer are dim and do not work at all when the running lights are turned on. The most common cause for this type of issue is a weak ground. A weak ground connection will…

view full answer...

Answer 8

It is most likely a ground issue that is causing the problems you described on your trailer. Since several lights are behaving strange I would first check to make sure the main ground for the trailer is connected to a clean metal surface. You can…

view full answer...

Answer 9

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 10

The ground wire on a trailer's wiring harness (usually a white wire) should be firmly attached to clean bare metal on the trailer frame. The white ground wire on the vehicle's wiring harness should similarly be attached to clean bare metal on…

view full answer...

Answer 11

I spoke with my contact at Optronics and was informed that the Lumen difference between part #STL70RB and part #STL22RB LED stop, turn and tail lights is not tested by Optronics. I was told that the more LED lights in the tail light the brighter the…

view full answer...

Answer 12

Based on the picture you submitted it looks like you are looking for the part #STL22RB which is an LED version of the light you have that has 12 light emitting diodes.

view full answer...