Quick Disconnects for Superwinch Tiger Shark 9.5K Winch # SW1595201

Question

Question:

What gauge is the main power wire for this? I want to get a quick connect to make it mobile.

asked by: Jason

0

Expert Reply:

Electric winches over 9K such as # SW1595201 tend to use 2 gauge wire. For this particular winch I recommend wiring kit # BDW20207 which comes with quick disconnects and the wiring. If the winch is going to be at the front of a vehicle I recommend # BDW20205.

And for quick disconnects by themselves you can use # BDW20133.

expert reply by: Michael H

0

Answer 1

You have already pointed out the differences with the number of bearings and the other difference is capacity rating. The CargoGlide 1500XL Sliding Tray for Trucks - Heavy Duty - 1,500 lbs - Steel Frame - 8" Rail #CG1500XL-9548 has 36 bearings…

view full answer...

Answer 2

You can add a heavier axle to the trailer but the rest of the components of your trailer may not be rated for a higher weight capacity such as the suspension components and wheels. If you go from a 3,500 lb axle to a 7,000 lb axle like part #8327834…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 5

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Answer 6

The largest MORryde RV Generator Slide Out Tray we offer is part #MR79RR which has inside dimensions of 24" long x 24" wide so it will be a good fit for a Predator Generator. Please note, it's not advised to run the generator whilst on…

view full answer...

Answer 7

No, it really isn't but I have a solution. The MORryde RV Generator Slide Out Tray item #MR79RR is designed to be mounted in storage compartments. It needs a sturdy base to support the weight of your generator and you're not going to be able…

view full answer...

Answer 8

For the MORryde #MR79RR slide out generator tray, there is not a lock or latch for the full out position. If it were me, I would look for a place to place a wedge to keep it out as necessary. I can't see any reason that you cannot run a generator…

view full answer...

Answer 9

The MORryde RV Generator Slide Out Tray #MR89RR has internal tray dimensions of 17-1/2" long, 20-3/8" wide, and the sides are 2-3/4" tall. Your Predator generator shows the measurements at the widest points at 17.3" deep,…

view full answer...

Answer 10

The MORryde RV Generator Slide Out Tray #MR79RR has a 1.38" clearance from the ground to tray.

view full answer...

Quick Disconnects for Superwinch Tiger Shark 9.5K Winch # SW1595201

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching