Review of Superwinch Electric Winch - Tiger Shark Off Road Winch Synthetic Rope Hawse - SW1595201 Video

From what I was able to determine, the Badland ZXR 9000-lb winch uses standard 10" x 4.5" bolt pattern, which will work well with the available mounting pattern on the Bulldog Winch Hitch Mounted Winch Mounting Plate with Handles…

Yes, the Superwinch Tiger Shark Series Off-Road Winch #SW1595200 that you referenced and the Bulldog Winch Hitch Mounted Winch Mounting Plate with Handles #BDW20011 are compatible with each other. The winch has a 4-Bolt mounting pattern: 10"…

I have a winch mounting plate confirmed to work with your Warn M8274-50. The Bulldog Winch plate part #BDW20011 is confirmed to fit.. I've attached a video to show you the hole pattern will fit the 10 x 4-1/2 inch pattern.

The plate that the winch mounts to is 1/4 inch thick. This mount has 2 sets of four (eight) holes, centered on the cable opening, in a rectangular pattern for mounting the winch to the plate and the measurements are 6-1/2 by 4-1/2 inches on center…

Electric winches over 9K such as #SW1595201 tend to use 2 gauge wire. For this particular winch I recommend wiring kit #BDW20207 which comes with quick disconnects and the wiring. If the winch is going to be at the front of a vehicle I recommend…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…