Erickson Truck Bed Ladder Rack to Fit 2014 Nissan Frontier Crew Cab with Utili-Track & 6-ft Bed

Question

Question:

Will this ladder rack fit on a 2014 Nissan Frontier Crew cab with utili-track system and 6 ft bed? When i search this rack for a 6ft bed it does not show it will work but it does show it will work for a 5ft bed ? Why would it fit the 5ft bed and not the 6ft bed? I am very interested in this rack but want to make sure it will fit my truck. If this rack will not work for my truck can you please suggest a ladder rack that will work? I do not want to drill any holes. Thank you

asked by: Markee

0

Expert Reply:

The Erickson ladder rack confirmed to fit your 2014 Nissan Frontier Crew Cab with Utili-Track system and 6-ft bed is their part # EM07708. This and other options for your truck are shown on the linked page. The other rack you referenced # EM07705 only fits certain specific versions of the Frontier, just not your particular version. Drilling is required.

expert reply by: Adam R

0

click to enlarge

Answer 1

I emailed my contact at SoftStart and inquired about the difference between the #SSR54FR and the SSRV3T. The products are exactly the same. The SSRV3T is simply SoftStart's internal part number which we refer to as part #SSR54FR.

view full answer...

Answer 2

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 6

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 9

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 10

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 11

I spoke with Lippert and they said the Kwikee 35 Series Electric RV 1-Step part #LC3691461 will be a direct replacement for the Coach Steps 725-0041. It will be a bolt-on install for the most part for the exception of changing out the door switch…

view full answer...

Answer 12

From your question it sounds to me like someone has cut off the tow package plug on your 2005 Ford F-150 and wired in a 4-way connector. In this case you could use the Hopkins Adapter 4-Pole to 7-Pole and 4-Pole, #37185 which will give you a 4-way…

view full answer...

Erickson Truck Bed Ladder Rack to Fit 2014 Nissan Frontier Crew Cab with Utili-Track & 6-ft Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching