Recommended Trailer Wiring Harness on a 2014 Audi A6

Question

Question:

I have a 2014 Audi A6 with AWD and did not see a custom wiring kit for adding a trailer hitch light package. Is there a problem with installing these systems on an A6. What is the recommended wiring package to use for this vehicle.

asked by: David B

0

Expert Reply:

We do not carry a custom wiring kit for your 2014 Audi A6. I recommend using the ZCI Circuit Protected Wiring Harness # 119250KIT on your Audi. This is a universal harness that does not require any splicing. Instead, it uses sensors that clamp around the car's wires to read the current that travels through the wire. I've attached an install video for you to take a look at.

If you don't already have a htich reciever on your A6, the Curt # C11423 is a Class I receiver confirmed to fit. It has a towing capacity of 2,000 pounds with a maximum tongue weight rated of 200 pounds. As always you should check your owner's manual to verify your vehicle doesn't have any restrictions on towing.

For a ball mount, an option is the Curt # C45521 that has a rise of 2-5/8 inches or a drop of 3-1/4 inches. Then either # A-82 for a 2 inch hitch ball or # A-80 for a 1-7/8 inch ball. Finally, # F-4 will work for a pin and clip.

expert reply by: Charles S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

For your 2014 Audi A6 we have the Curt hitch part #C11423 that is a confirmed fit and would work well for carrying a bike rack. I attached a picture that shows the hitch installed on a similar 2014 Audi A6 as well. Curt requires the use of their…

view full answer...

Answer 3

For your 2016 Audi A6 we have the Curt hitch part #C11423 that is a confirmed fit and would work well for you. For trailer wiring the best option is the ZCI kit part #119250KIT which instead of requiring you to hardwire into your veicles trailer…

view full answer...

Answer 4

Curt does list trailer hitch #C11423 as a fit for all models of the 2014 Audi A6 Quattro! I have included a link to the installation instructions for you. If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you…

view full answer...

Answer 5

I'll be the first to admit that the stabilizer strap requirement for Curt hitches like the part #C11423 is a hassle that most wish was avoidable. If you have the strap tight enough that it's damaging the vehicle then you'd want to back of…

view full answer...

Answer 6

We only have one hitch that's a confirmed fit for your 2014 Audi A6, the Curt part #C11423. This hitch does require fascia trimming though. The most popular bike rack we carry that has been confirmed to fit this vehicle is the Thule Camber 2 part…

view full answer...

Answer 7

The Curt Trailer Hitch Receiver part #C11423 while installed on a 2015 Audi A6 will provide around 7-1/2" of ground clearance. This will be fine for most hitch mounted accessories like bike racks but for cargo carriers you'll want to look…

view full answer...

Answer 8

I attached a picture that shows what gets trimmed when you install the Curt hitch part #C11423. The 2016 models need to be trimmed as well.

view full answer...

Answer 9

I attached a picture that shows what the Curt hitch part #C11423 looks like installed on a 2016 Audi A6 like yours. This will most likely take right at an hour for a shop to install so most likely you'd get charged one shop hour. If you need a…

view full answer...

Answer 10

Stabilizer straps aren't recommended or required for carrying heavier bike racks like what you plan to do with your 2020 Subaru Forester. I don't recommend going that route as I'd hate to see you damage your new vehicle. Instead I'd…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Recommended Trailer Wiring Harness on a 2014 Audi A6

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching