Fit Curt Class III Receiver Part # 13147 for a 2011 Subaru Forester

Question

Question:

Will this 2 hitch fit the 2011 Subaru Forester? I dont think any body changes since 2010...

asked by: Mark W

0

Expert Reply:

The Curt Class III hitch you referred to, part # 13147 is a fit for all models of the 2009-2013 Forester. It will indeed fit your 2011 model. However, be aware that Curt's warranty stipulates that a reinforcing strap like part # 18050 must be used on any non trailer load like a bike rack or cargo carrier. Some find the strap difficult to use, and if your Forester has the spoiler atop the rear hatch, the strap might damage it.

For this reason, I'd recommend the Draw-Tite Class III hitch, part # 75650, which won't require a strap be used. If you'll be towing with your hitch, you might also need the following:

Trailer wiring harness w/ 4-pole trailer connector, part # 118467
Ball mount, part # C45010
1-7/8 inch trailer ball, part # 19260
2 inch trailer ball, part # 63845
Locking hitch pin, part # 40107

I've linked you to install videos for the hitch and the trailer wiring.

expert reply by: Mike L

0

Answer 1

Either the Curt Hitch #13147 or the Draw-Tite Hitch #75650 would work very well for you. The main difference between the two is the tube design like you noticed. There is not an advantage to having a round tube over a square tube hitch or vice…

view full answer...

Answer 2

We have everything you will need to tow a tent trailer like what you are looking at with your 2010 Subaru Forester. First let's start with a hitch. Since 2 inch hitches have higher capacities and have more hitch accessories made for them I…

view full answer...

Answer 3

The Curt part #13147 and Hidden Hitch part 87493 are similar designs as they are built to fit the same vehicles. There are a couple of key differences that may help you in making a decision. Curt uses a high-gloss black finish on their hitches and…

view full answer...

Answer 4

I checked the owner's manual in regards to the towing capacity of your 2011 Subaru Forester, and it states that the maximum towing capacity is 1,000 lbs if the trailer does not have brakes or 2,400 lbs if the trailer does have brakes. So that…

view full answer...

Answer 5

Typically two batteries are needed for a 2,000 watt inverter like the part #34278156 that you referenced.

view full answer...

Answer 6

For the Go Power Industrial Pure Sine Wave Inverter, #34278156 rated for 2,000 Watt, if you want to operate anything for an extended period of time that needs that large of an inverter I suggest at least 400 AH minimum in your battery bank. So your…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...