What is the Height Range of the Brophy Cable Camper Jack Set CJ74

Question

Question:

I have a Jeep J10 pickup and was wondering how low can the jacks go? The closer to the ground the better so I can safely store the camper in the off season. Thanks!

asked by: Kevin G

0

Expert Reply:

The height range possible with the Brophy Cable Camper Jack Set # CJ74 tops out at 67-inches maximum down to a minimum of 17-inches, giving it a 50-inch operating range. The kit offers a 3000-lb total weight capacity and a 4-to-1 winch gear ratio. For safety always use the jacks on level ground.

expert reply by: Adam R

0

Answer 1

The Brophy Cable Camper Jacks part #CJ74 can be used for storage but if the side of the camper do not extend to or past the sides of the truck bed it would not be feasible for them to be used for loading/unloading. That said, you could somehow…

view full answer...

Answer 2

As long as the camper shell weighs less than the 3,000 lb capacity of the #CJ74 Camper jacks, you should only need one set. The lift bracket itself is 26-1/2 inches long, so be sure to place the brackets at the center of gravity of the camper shell…

view full answer...

Answer 3

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is…

view full answer...

Answer 4

You should be able to change the orientation of the Brophy Cable Camper Jacks #CJ74 so that the legs pointing towards the cab of your pickup and the other legs will sit under your pickup bed a little to help stabilize your camper. I have attached a…

view full answer...

Answer 5

You should not have a problem with the camper sliding out when you are using any of the Brophy Cable Camper Jacks. The jack is very stable because of the tripod base. That stability will make the jack very difficult to tip to the front or the back.…

view full answer...

Answer 6

While the pipe diameters are the same the rest of the Brophy Cable Camper Jacks #CX74 and #CJ74 are different. The tripod bases have different bracing and the winch mount that has the angle iron section welded to it has different bracing as…

view full answer...

Answer 7

You will want a space between the Timbren Suspension Enhancement System - Rear Axle item #TDRTT3500E and your axle. The installation instructions call for a 1 inch gap. The only time there shouldn't be a space is when the rear of your 2022 Ram…

view full answer...

Answer 8

The Brophy Cable Camper Jack part #CJ74H does break down into 3 pieces for storage however the pully portion of the Camper Jack (winch) is not removable because it is welded on. I have attached a photo of the camper jack disassembled.

view full answer...

Answer 9

The Brophy Heavy Duty Cable Camper Jacks #CX74 may be able to work for you depending on the configuration of your camper. They do not have the same design in terms of fitting into the corners of your '73 Ford camper; the Brophy #CX74 uses…

view full answer...

What is the Height Range of the Brophy Cable Camper Jack Set CJ74

Product Page this Question was Asked From

Continue Researching