Replacement Master Cylinder for Titan Model 60 Hydraulic Trailer Brake Actuating Coupler

Question

Question:

looking for a replacement part for Titan Model 60

asked by: Dan

0

Expert Reply:

We do indeed offer replacement master cylinders for the Titan Model 60 hydraulic trailer brake actuating coupler. If you have a disc brake system, the correct replacement would be part # T4820000 or # T4395100 for drum brake systems.

expert reply by: Jackie C

0

Answer 1

I've looked through the various replacement master cylinders we offer, and couldn't find anything that matches your photo. I found out that Reliable stopped manufacturing brake actuators several years ago, and replacement parts aren't…

view full answer...

Answer 2

To replace the calipers on your boat trailer you will need to know the weight capacity for the axle that is on the boat trailer and the brand of the calipers. A very common brand is the Kodiak calipers, typically they will have 225 stamped on the…

view full answer...

Answer 3

From my research the hub and rotor assembly you're looking for is for a 3,500 pound axle with a 5 on 4-1/2 bolt pattern. It uses bearings #L68149 and #L44649 and has a Dacromet finish for marine use. If the bearing numbers match you can use…

view full answer...

Answer 4

We can help you with either new disc brakes or with replacement parts for your existing disc brake setup on your Ranger boat trailer. Either way you will want to confirm the axle rating of the single or tandem axles on the trailer since complete…

view full answer...

Answer 5

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Answer 6

I have a different option for you, but the Kodiak Disc Brake Kit #K2HR526D you were looking at is designed for 5,200 - 6000lb axles and as such will not work with your 3,500lb Dexter axle. Instead you will need to go with the 3,500lb Disc Brake Kit…

view full answer...

Answer 7

Based on the issue you are describing the Tie Down Engineering Surge Brake Coupler Model 8000 on your trailer has a shock that is worn out, but since this model actuator has been discontinued there are no replacement parts available any longer. Your…

view full answer...

Answer 8

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...