bing tracking image
Q & A Icon

ABS Warning Lamp Comes On Once Brake Controller Installed  

Question:

Hooked everything up and now my break light and abs r lit up. Actually when i tapped the break peddle switch they remain on now.

0

Expert Reply:

When a brake controller installation causes the ABS warning lamp to go off, it indicates that the red wire from the brake controller is connected to the wrong wire. If the brake controller was hardwired, the red brake controller wire should be tapped into the wire that only shows voltage on it with the brake pedal pressed, not with the turn signal, head lights or any other function. Use a circuit tester like # PTW2993 to confirm that the circuit the red brake controller wire is tapped into only shows voltage when the brake pedal is pressed.

If a brake controller wiring adapter harness was used, be sure you're using the correct harness for the year, make and model of your vehicle. You can use our fitguide to input the year, make and model of vehicle, then click on the brake controller option where you'll be shown the correct wiring adapter for your vehicle.

I've linked you to some FAQ articles about brake controllers, which I hope you'll find helpful.

expert reply by:
0
Mike L

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>