What Size Bolts Come with Draw-Tite Part # 75684

Question

Question:

What size bolts for hitch

asked by: Gary A

0

Expert Reply:

The Draw-Tite part # 75684 comes with install bolts that are M10 x 1.25 x 30mm.

If you needed to order replacements from us you would need the part # RHK. On the product page you would enter the part number of this hitch and then select Draw-Tite as the manufacturer.

expert reply by: Jameson C

0

Answer 1

I recommend Draw-Tite Class III Max Frame Receiver Hitch part #75684 for the 2013 Kia Sorento LX. However, the Draw-Tite hitch will not give you 500 lbs of tongue weight capacity. The highest rated hitch option for the Kia Sorento LX is 350 lbs. If…

view full answer...

Answer 2

Before we determine that you have the wrong size install bolts you need to make sure that the bolts not fitting isn't due to the weld nuts of your vehicle being dirty/corroded and that is why they won't fit. Typically on vehicles that have…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...