Bulldog Inner Tube Gooseneck Coupler Availability that is 4 inches In Diameter

Question

Question:

Do you sell a trailer coupler like BD0287610300, but without the pin holes? I need one just like your BD0287690300 but will fit up in the 4 inch pipe. I guess the BD0287610300 will work but with my current set up I do not need to or never had to it down

asked by: Patrick L

0

Expert Reply:

Since you need a 4 inch diameter pipe the best option we have is the part # BD0287610300 as it has a 4 inch outer diameter whereas the # BD0287690300 that you referenced would be too wide at 4-1/2 inches.

Or the part # CG would work too as it is 4 inch diameter and has no pin holes.

expert reply by: Jameson C

0

Answer 1

The B&W Companion 5th Wheel Trailer Hitch #BWRVK3500 (RVK3500) is the complete 5th wheel hitch that will mount to an existing B&W Turnoverball Gooseneck Hitch socket in the truck bed. The part #BWRVB3500 (RVB3500) that you also referenced is…

view full answer...

Answer 2

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Answer 3

We do actually have Dexter electric drum brakes in your required 10 x 1-1/2-inch size, parts #K23-473-00 and #K23-472-00, which are right- and left-hand, respectively. These are complete bolt-on (4-bolt) replacements that fit wheels diameters from…

view full answer...

Answer 4

I do have an option for you but Atwood was bought out and their replacement parts are no longer available, including the repair kit you would need. The best option is to replace that A-frame coupler with a new one that attaches to a 2 inch hitch…

view full answer...

Answer 5

You can absolutely wire up a 3-wire breakaway switch like the Hopkins LED Breakaway Switch with 7" Lead Wires #HM20059 to replace your 2-wire switch; the difference is that the 3-wire switch has a dedicated ground wire while the 2-wire switch…

view full answer...

Answer 6

The spindle that would work with the hub #8-174-5UC3 you mentioned is the TruRyde Spindle, part #TRU57FR. This spindle includes the washer, castle nut, and pin. This has a 2,500 lb capacity. I have attached a product review video for this spindle you…

view full answer...

Answer 7

The 10" x 1-1/2" braking assemblies part #K23-472-473-00 will use the same four bolt brake mounting flange as the 10" x 1-3/4" braking assemblies you have but the hub/drum that goes with these uses a LM67048 inner bearing and…

view full answer...