Fit of SportRack Semi Custom # SR1002 Roof Rack on 2005 Toyota Corolla w/ Factory Sunroof

Question

Question:

Hi, Im interested in the sportrack for a 2005 Toyota Corolla, SR1002 I have a factory installed sunroof. Will this rack still work? Thanks

asked by: Tom M

0

Expert Reply:

According to SportRack, the # SR1002 is indeed compatible with 2005 Corolla models equipped with the factory sun roof. However, if the sunroof increases the roof height of the vehicle when it's opened, the rack or rack mounted accessories might interfere with the sunroof operation or damage it.

expert reply by: Mike L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

The feet are not separate replacement parts for the SportRack Semi-Custom Roof Rack for Naked Roofs - Square Crossbars - Steel - 50" Long #SR1002. You will need to replace the entire unit to get the feet.

view full answer...

Answer 9

The best way to pick out a fairing for a roof rack is to go with the length of fairing that matches the distance between the feet of the roof rack the best. So for a 50 inch long crossbar most likely the 44 inch long fairing would be the best choice…

view full answer...

Answer 10

All roof racks do make noise. At highway speeds especially the least-noisy bar type is the elliptical shape, also known as an aero-style bar. These make less noise than round and square bars but they still make noise. We have a solution for your…

view full answer...

Answer 11

The best size cargo carrier for your 2017 Hyundai Santa Fe would be one that will fit the roof of your vehicle, offer you enough capacity to carry the cargo you need, and not interfere with the operation of your vehicle's rear hatch. The Thule…

view full answer...

Answer 12

For a basic roof rack system to haul fishing rods on your Corolla I would recommend the SportRack #SR1002 roof rack with 50" crossbars. To that add the Rhino-Rack #RR572 4-pole locking fishing rod holder. Optionally you could use the Rhino-Rack…

view full answer...