How Difficult is it To Change Springs Back to Bottom of Axle

Question

Question:

putting springs on top of axles how hard is it to change the springs back to the bottom of the axle

asked by: Shelby

0

Expert Reply:

Sounds like you want to move your springs to the top of the axle and want to know how hard it would be to move them back. All you will have to do is reverse what you did to put them on top of the axles. All you will need is the Dexter Trailer Springs Over-Under Conversion Kit like # K71-385-00, if you have a 3 inch round axle, or # K71-384-00 if you have a 2-3/8 inch round axle.

expert reply by: Chris O

0

Answer 1

Based on the picture you submitted that shows a square axle welded to a mount which is then welded to a leaf spring you would need to have someone qualified use a cutting torch to remove the mount from the spring so that you could then use a u-bolt…

view full answer...

Answer 2

Torque specs for wheel lug nuts vary depending on several factors like stud size, wheel size and wheel material. The linked image provides a listing of commonly recommended torque values. The studs on your hubs #A35RS545E are 1/2-inch diameter and…

view full answer...

Answer 3

The Curved Equalizer part #TREQE1 which measures 7-3/4" long is only really offered in one height which is 4-1/4". That said, installing a taller equalizer will not really raise the trailer if that is what you are after. It would only do so…

view full answer...

Answer 4

The Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-3/4" Tall Front/Center/Rear #APT5 has the wider 7-3/4 inch equalizers you referenced but all holes are 9/16 inches (top and bottom). All of our kits will have the 9/16 inch bolts.…

view full answer...

Answer 5

I do not recommend using higher capacity springs because that will give you a stiff ride. Also the different springs may require a different hanger orientation and since the hangers are welded on this is a professional job since the old ones have to…

view full answer...

Answer 6

If your axles are currently under the leaf springs then an over-under kit would not be the correct product to use as it would not actually raise your trailer. It would lower it. If you cannot use an over/under conversion kit then the only other way…

view full answer...

Answer 7

The weight of a trailer is transferred evenly by the equalizers to the suspension system(springs, shackles and hangers), and the equalizers do not have a weight capacity listed. The equalizer allows for a smooth transfer of impact caused by rough or…

view full answer...

Answer 8

Aside from moving the axles below the leaf springs the only other way we recommend you lift a trailer is by installing taller spring hangers on the trailer frame. What you would need to do is measure the dimensions of your current hangers and then…

view full answer...

Answer 9

Placement of the axles depends on several factors and there is a formula that you can follow to determine the best placement of the axles. Take a look at the picture I have included which explains how to determine where axles should be placed. Once…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

How Difficult is it To Change Springs Back to Bottom of Axle

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching