Brake Controller Wiring Adapter for 2013 Dodge Durango with Factory 7-Way
Question:
I have a 2013 Dodge durango with factory 7 pin package, 3021-P and TK93VRboth show as Dodge compatible connectors, what is correct?
asked by: Mark
0
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Are There Any Trailer Hitch Fits for a 2023 Ford Escape Plug-In Hybrid
- Q&A: Brake Controller Plug Location on 2021 Jeep Grand Cherokee
- Q&A: Replacement Key Needed for Gorilla Guard Trailer Coupler Lock
- Article: Pintle-Hitches
- Article: Brake Controller Installation: Starting from Scratch
- Article: Big Truck Big RV
- Q&A: Where is Brake Controller Install Connector for 2022 Jeep Grand Cherokee 4xe
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)