Reverse Lock Out Solenoid Availability

Question

Question:

I have a 2005 magic tilt TML 2460 and I think the brake solenoid is bad. I was wondering if there is a replacement besides the $80 solenoid from magic tilt? Thanks

asked by: Tyson

0

Expert Reply:

Are you talking about the reverse lockout solenoid? We have a couple of those. If you have a Titan actuator you would want part # T4748800, or a Demco part # DM5404.

expert reply by: Jameson C

0

Answer 1

I checked your order notes and you do have a Model 10 actuator which is what the solenoid part #T4748800 is designed to fit. When you put the vehicle in reverse can you hear the solenoid click? That would indicate it is activating. It sounds like you…

view full answer...

Answer 2

I checked the instructions for the Demco Solenoid Kit #DM5404 and though it is a little vague, you will want to have the flared inlet attached to the actual brake line and the flat inlet attached to the #6 fitting (which then attaches to the master…

view full answer...

Answer 3

The Demco Solenoid Kit for Brake Actuators with Reverse Lockouts part #DM5404 will work with both the 1200 PSI actuators for drum brakes and the 1600 PSI actuators for disc brakes.

view full answer...

Answer 4

Demco Solenoid Kit (Bypass) #DM5404, when energized, will only allow the brake fluid to flow back into the master cylinder. A non-bypass, when energized, will just prevent the fluid from flowing anywhere. The type used depends on the master cylinder…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 10

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 11

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…

view full answer...

Reverse Lock Out Solenoid Availability

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching