What Pressure Brake Actuators will the Demco Solenoid Kit part # DM5404 Work With

Question

Question:

I would like to know what PSI this valve is rated for. Thank you

asked by: Scott

0

Expert Reply:

The Demco Solenoid Kit for Brake Actuators with Reverse Lockouts part # DM5404 will work with both the 1200 PSI actuators for drum brakes and the 1600 PSI actuators for disc brakes.

expert reply by: Randy B

0

Answer 1

I checked the instructions for the Demco Solenoid Kit #DM5404 and though it is a little vague, you will want to have the flared inlet attached to the actual brake line and the flat inlet attached to the #6 fitting (which then attaches to the master…

view full answer...

Answer 2

Demco Solenoid Kit (Bypass) #DM5404, when energized, will only allow the brake fluid to flow back into the master cylinder. A non-bypass, when energized, will just prevent the fluid from flowing anywhere. The type used depends on the master cylinder…

view full answer...

Answer 3

Are you talking about the reverse lockout solenoid? We have a couple of those. If you have a Titan actuator you would want part #T4748800, or a Demco part #DM5404.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...