Welding E-Track in Place on a Steel trailer Recommendation

Question

Question:

Do you have a recommendation on how to weld E-track to a steel trailer bed? 3 inches of weld every 10?

asked by: Mike O

0

Expert Reply:

There are no specific welding installation instructions for attaching E-tracks like the part # E19148 that you referenced. But what you suggested should work very well. Doing 3 inches of welding for every 10 inches should provide a strong attachment.

Since this has a galvanized finish you will want to weld in a very well-ventilated area.

expert reply by: Jameson C

0

Answer 1

The typical installation of the Erickson Horizontal E-Track, part #E19148 is by installing bolts or screws through the mounting holes on the track system. It can be welded, but specific precautions should be used when doing so as this is a…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 4

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 5

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

You will use metal screws to install the etrailer Horizontal E-Track #e42VR. You'll also need backing plates to install this e-track and the mounting hardware is actually included with the etrailer E-Track Backing Plates with Hardware #e76YR. The…

view full answer...

Answer 11

Yes, the Torklift Class V hitch part #TLC1205 would be a great option for your 2002 Chevy Silverado 2500HD long bed. If you instead had a short bed truck you would want the part #TLC1204. The 17k capacity is more than what your truck is rated for so…

view full answer...